PWM Charge Controllers

MMTP

PWM Charge Controllers

SOLAR CHARGE CONTROLLERS


With smart solar charge controller using microcontroller you can charge batteries in a smarter, more effective and efficient way that increases their overall life time. Pulse width modulation technique is used to charge the batteries and PIC microcontroller is used to generate PWM. There are multiple models available ranging from 12 V / 5 Amps PWM to 24 V / 20 Amps MPPT.

Enquiry Now
ModelRE-PCC-1203RE-PCC-1210RE-PCC-2410
Application Indoor  
ConstructionCRCA Powder Coated Box  
Ingress ProtectionIP 21  
Nominal Operating Voltage12 V DC12 V DC12 V / 24 V DC (Automatic selection)
Solar Charge Controller12 V, 3 A12 V, 10 A with LCD12 V, 20 A / 24 V, 10 A with LCD
Solar Charge Controller TypePWM  
Charging MethodologyLinear charging  
Recommended SPV Module12 V, 40 Wp (max.)12 V, 200 Wp (Max.)24 V, 300 Wp (Max.)
Voc of SPV Module21 Volts21 Volts44 Volts
Recommended Battery12 V, 20 Ah with Lead Acid & 12.8V, 6 Ah with LiFePo4 (max.)12 V, 100 Ah with Lead Acid & 12.8V, 60 Ah with LiFePo4 (max.)12 V, 200 Ah with Lead Acid & 12.8V, 120 Ah with LiFePo4 (max.)
Max. Output Load12V DC, 2A12V DC, 8A12V DC, 15A
Charging & Load Efficiency>90%  
Mobile Charging Unit5 V, 1 A USB Port type  
LCD ParametersNAPV Volt, PV Current, PV Power, Batt. Volt, Batt. current, Load current, Load Power, Battery percentage, Load ON/OFF status, Fault status.PV Volt, PV Current, PV Power, Batt. Volt, Batt. current, Load current, Load Power, Battery percentage, Load ON/OFF status, Fault status.
IndicationsYellow: System On, Red: Battery Low, Green: ChargingYellow: Battery Low, Red: Fault& Green: ChargingYellow: Battery Low, Red: Fault& Green: Charging
Connectors usedTerminal block connectors are used for connect Load, Battery and Solar panel.  
Std. ProtectionsReverse polarity, Short circuit and Open circuit, Battery over flow, Deep discharge & Over charge protections.